Collapse temperature is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2026-08-01. Numbers and descriptions here follow the published literature rather than marketing material.
Freezing determines ice crystal structure and pore size, which affect drying speed and product uniformity. Rapid freezing creates small crystals, while slow freezing creates larger crystals and often faster sublimation. During primary drying, chamber pressure is held below the vapor pressure of ice, and shelf temperature supplies heat for sublimation. The ice front recedes, leaving a porous matrix. Thermal limits such as collapse and eutectic temperatures set safe boundaries for formulation. These limits vary with solute composition and concentration.
Secondary drying removes bound water that remains after ice sublimation. Shelf temperature is raised gradually while pressure remains low, reducing water content to a target range. Over-drying can cause brittleness or electrostatic issues, while under-drying affects stability. The endpoint is often judged by pressure rise tests, temperature measurements, or water content analysis. Scale-up depends on matching heat and mass transfer across equipment sizes. Small changes in shelf temperature or pressure can alter cycle length substantially.
Lyophilization removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts liquid water into ice and concentrates dissolved solids. Primary drying then lowers chamber pressure so ice changes directly into vapor without passing through a liquid phase. Secondary drying raises the shelf temperature to remove bound water that remains after ice sublimation. The result is a dry, porous structure that can be reconstituted later.
Formulation composition influences whether freeze-drying produces an intact cake or a collapsed mass. Excipients such as sugars and polymers can raise the collapse temperature and provide bulk during drying. The critical temperature for primary drying is often the collapse temperature or the glass transition temperature of the maximally concentrated phase. If the product temperature exceeds this threshold, the frozen matrix may soften and lose structure. Established practice therefore links shelf temperature and chamber pressure to the formulation's thermal properties.
| Property | Value | Notes |
|---|---|---|
| Process name | Lyophilization or freeze-drying | Both terms appear in technical standards and literature. |
| Phase transition | Sublimation | Solid ice becomes vapor without a liquid step. |
| Typical chamber pressure | 0.05-0.5 mbar | Range depends on product temperature and equipment. |
| Typical product temperature | -40 °C to -10 °C | Measured during primary drying; formulation sets limits. |
| Water content after drying | 0.5-3% w/w | Target varies by material and stability needs. |
Lyophilization is a dehydration process that removes water from a frozen material by sublimation under low pressure. The material is first frozen so that water becomes ice; then the surrounding pressure is lowered below the vapor pressure of ice. Heat is applied gently so ice changes directly to vapor without passing through a bulk liquid phase. The vapor is collected on a cold condenser, leaving a dry porous matrix. This process differs from simple evaporation because the material remains frozen during the main drying stage.
The process usually has three stages: freezing, primary drying, and secondary drying. Freezing sets the ice crystal structure and can determine pore size in the final cake. Primary drying removes free ice by sublimation at low pressure and low shelf temperature. Secondary drying removes bound water by raising the shelf temperature, although some water may remain as part of the solid. Cycle parameters depend on formulation, fill volume, vial type, and equipment performance.
The physical chemistry of freezing influences whether a formulation forms an amorphous glass or a crystalline solid. Amorphous systems can collapse if product temperature rises above the glass transition temperature of the freeze concentrate. Crystalline systems may show eutectic melting, where ice and solute melt together at a fixed temperature. Formulators add bulking agents, lyoprotectants, and buffers to preserve structure and biological activity. The optimum cycle keeps product temperature below critical thresholds during primary drying while allowing efficient sublimation.
Lyophilization is a dehydration process that removes water from a frozen material by sublimation under low pressure. The material is first frozen to convert liquid water into ice. Next, the pressure is reduced below the triple point of water so that ice changes directly into vapor without passing through a liquid phase. This step is called primary drying. The result is a porous solid or cake that retains the original shape of the frozen solution.
After primary drying, secondary drying removes water that remains bound to the material. This stage raises the shelf temperature while maintaining low pressure, which encourages desorption of unfrozen water. Residual moisture can be reduced to a low percentage, improving stability for many products. The process parameters, including freezing rate, shelf temperature, and chamber pressure, influence the final pore structure and reconstitution behavior. Control of these variables helps prevent collapse or meltback during drying.
Lyophilization removes water by freezing a material and then lowering pressure so ice changes directly to vapor. The process relies on sublimation, the phase transition from solid to gas without an intermediate liquid state. Because the material remains frozen during primary drying, the structure often stays porous. This porous matrix can rehydrate quickly when water is added back. The low pressure also allows vapor to leave the solid matrix without boiling.
A typical cycle begins with freezing, which fixes the material into a solid and determines ice crystal size. Primary drying then raises heat under vacuum so ice sublimes, often near or below the collapse temperature of the formulation. Secondary drying removes bound water that remains after ice is gone, usually by gently warming the product. Each stage balances heat input against pressure to avoid melting or structural damage. Temperature probes and pressure sensors guide the transition between stages.
== Signs and symptoms == The symptoms of rhabdomyolysis depend on its severity and whether kidney failure develops. Milder forms may not cause any muscle symptoms, and the diagnosis is based on abnormal blood tests in the context of other problems. More severe rhabdomyolysis is characterized by muscle pain, tenderness, weakness, and swelling of the affected muscles. If the swelling is very rapid, as may happen with a crush injury after someone is released from under heavy collapsed debris, the movement of fluid from the bloodstream into damaged muscle may cause low blood pressure and shock. Other symptoms are nonspecific and result either from the consequences of muscle tissue breakdown or from the condition that originally led to the muscle breakdown. Release of the components of muscle tissue into the bloodstream causes electrolyte disturbances, which can lead to nausea, vomiting, confusion, coma or abnormal heart rate and rhythm. The urine may be dark, often described as "tea-colored", due to the presence of myoglobin. Damage to the kidneys may give rise to decreased or absent urine production, usually 12 to 24 hours after the initial muscle damage. Swelling of damaged muscle occasionally leads to compartment syndrome—compression of surrounding tissues, such as nerves and blood vessels, in the same fascial compartment—leading to the loss of blood supply and damage or loss of function in the part(s) of the body supplied by these structures. Symptoms of this complication include pain or reduced sensation in the affected limb.
In late 1915 the British High Commissioner to Egypt, Henry McMahon, exchanged ten letters with Hussein bin Ali, Sharif of Mecca, in which he promised Hussein to recognize Arab independence "in the limits and boundaries proposed by the Sherif of Mecca" in return for Hussein launching a revolt against the Ottoman Empire. The pledge excluded "portions of Syria" lying to the west of "the districts of Damascus, Homs, Hama and Aleppo". In the decades after the war, the extent of this coastal exclusion was hotly disputed since Palestine lay to the southwest of Damascus and was not explicitly mentioned.
== Pathology == While most cells require the action of insulin for glucose to gain entry into the cell, the cells of the retina, kidney, and nervous tissues are insulin-independent, so glucose moves freely across the cell membrane, regardless of the action of insulin. The cells will use glucose for energy as normal, and any glucose not used for energy will enter the polyol pathway. When blood glucose is normal (about 100 mg/dL or 5.5 mmol/L), this interchange causes no problems, as aldose reductase has a low affinity for glucose at normal concentrations. In a hyperglycemic state, the affinity of aldose reductase for glucose rises, causing much sorbitol to accumulate, and using much more NADPH, leaving less NADPH for other processes of cellular metabolism. This change of affinity is what is meant by activation of the pathway. The amount of sorbitol that accumulates, however, may not be sufficient to cause osmotic influx of water. NADPH acts to promote nitric oxide production and glutathione reduction, and its deficiency will cause glutathione deficiency. A glutathione deficiency, congenital or acquired, can lead to hemolysis caused by oxidative stress. Nitric oxide is one of the important vasodilators in blood vessels. Therefore, NADPH prevents reactive oxygen species from accumulating and damaging cells. Excessive activation of the polyol pathway increases intracellular and extracellular sorbitol concentrations, increased concentrations of reactive oxygen species, and decreased concentrations of nitric oxide and glutathione.
Sources: en.wikipedia.org
It is available as the following salts, in approximate descending order of frequency of use: bitartrate, phosphate, hydrochloride, tartrate, hydroiodide, methyliodide, hydrobromide, sulfate, and thiocyanate. The salt to free base conversion factors are 0.67 for the bitartrate, 0.73 for the phosphate, and 0.89 for the hydrochloride. Dihydrocodeine is the parent drug of a series of moderately strong narcotics including, among others, hydrocodone, nicocodeine, nicodicodeine, thebaine and acetyldihydrocodeine. It is an original member and chemical base of a number of similar semi-synthetic opioids such as acetyldihydrocodeine, dihydrocodeinone enol acetate, dihydroisocodeine, nicocodeine, and nicodicodeine. Whereas converting codeine to morphine is a difficult and unrewarding task, dihydrocodeine can be converted to dihydromorphine with very high yields (over 95%). Dihydromorphine is widely used in Japan. The dihydromorphine can be quantitatively converted to hydromorphone using potassium tert butoxide. Dihydrocodeine can be presumptively detected by the Froehde reagent.
=== February === 3 February – Prime Minister Keir Starmer rejects an allegation that he broke COVID-19 regulations by having a voice coach present at a press conference where he responded to a Brexit deal negotiated by Boris Johnson. For the first time, Reform UK have led an opinion poll, after coming top with 25% in a YouGov poll for Sky News. Labour are second on 24%, with the Conservatives on 21%. Northern Ireland's Economy Minister, Conor Murphy steps down from the post and announces he will leave Stormont after being elected to the Irish Seanad. Caoimhe Archibald is appointed to replace him as Economy Minister. 4 February – BBC News reports that Jack Lopresti, the former Conservative MP for Filton and Bradley Stoke who lost the seat at the last general election has joined the Ukrainian military. Welsh Conservatives leader Darren Millar and his colleague Russell George miss a Senedd vote on the Eluned Morgan government's budget for 2025–26 because they have travelled to the United States for the annual National Prayer Breakfast. 5 February – Deputy Prime Minister Angela Rayner confirms that local elections in East Sussex, West Sussex, Essex, Thurrock, Hampshire, the Isle of Wight, Norfolk, Suffolk and Surrey will be delayed for a year to allow major local government reorganisations to take place. Four of the seven MPs suspended from the Labour Party for voting against the child benefit cap are readmitted to the party; they are Richard Burgon, Ian Byrne, Imran Hussain and Rebecca Long-Bailey.
==== 1935–1949 ==== Teva Pharmaceutical Industries took its present form through the efforts of Günther Friedländer and his aunt Else Kober on May 1, 1935. The original registration was under the name Teva Middle East Pharmaceutical & Chemical Works Co. Ltd. in Jerusalem, then part of Mandatory Palestine. Friedländer was a German pharmacist, botanist and pharmacognosist, who immigrated to Mandatory Palestine in 1934. The company was built with an investment of £4,900, which came from the family's own capital and partly from loans from other German immigrants. Capital shortage led to the joining of the banker Alfred Feuchtwanger as a partner in Teva, who received 33% of the shares in return for his investment. Friedländer's business philosophy opined that the pharmaceutical industry has a reliable basis in difficult economic times, since "A Jewish mother will always buy medicine for her children". In the Second World War, the company provided medicine to the allied forces and in particular to the British army present in the Middle East. After the war, Sir Alan Gordon Cunningham, the last of the High Commissioners for Palestine and Transjordan, visited Teva on behalf of the Secretary of State for the Colonies. His visit promoted Teva's reputation in the pharmaceutical market and created a momentum for Teva's development. During Mandatory Palestine, Teva exported its medical products to Arab countries. In 1941, Friedländer presented Teva products in an exhibition held in Cairo, Egypt.
Sources: en.wikipedia.org
This led Santa Fe Opera to add one more performance. As well, Santa Fe Opera secured an agreement with the Dutch recording label Pentatone to produce a commercial recording of the opera, captured live from the Santa Fe Opera production. The director of the premiere production at Santa Fe Opera was Leonard Foglia, with set design by Robert Brill, lighting design by Brian Nason, costumes by David C. Woolard and projection design by Elaine J. McCarthy. Miguel Harth-Bedoya was the conductor. With respect to Opera Philadelphia, Cold Mountain is part of the company's "American Repertoire Program", a ten-year commitment to produce a contemporary American work each season. For the second production of Cold Mountain, at Opera Philadelphia, Higdon and Scheer made modest revisions. In late January 2016, Nathan Gunn withdrew from the Opera Philadelphia production because of a family medical emergency. Jarrett Ott, the understudy for Inman in both the Santa Fe Opera and Opera Philadelphia rosters, stepped into the role of Inman for the Opera Philadelphia performances. The Pentatone commercial recording of Cold Mountain was released in April 2016. It received two Grammy nominations.[1] In May 2016, Cold Mountain was the winner in the category of World Premiere at the International Opera Awards in London. In July 2019, Cold Mountain made its West Coast Premiere at the Music Academy of the West 2019 Summer Festival.
SO.FI.M.A. Società Finanziaria Macchine Automatiche S.p.A. - 56,789% (22.295.194 shares) Lopam Fin S.p.A. - 50% Cofiva (Dichiarante) - 24,65% Cofiva Holding spa - 99,9% Gianluca Vacchi - 55% Hydra S.p.A. - 2,003% (737.665 shares)
Nicotinamide riboside kinase 2 is an enzyme that in humans is encoded by the NMRK2 gene (previously ITGB1BP3). As a nicotinamide riboside kinase (EC 2.7.1.22), this enzyme functions to phosphorylate nicotinamide riboside which produces nicotinamide mononucleotide, an important enzyme cofactor. Nicotinamide riboside kinase 2 is primarily found in the muscle and heart, unlike the other known human isoform, nicotinamide riboside kinase 1, which is more widely expressed.
Sources: en.wikipedia.org
Conventional drying uses heat to evaporate liquid water, often at temperatures that can degrade sensitive materials. Lyophilization freezes the material first and then removes water by sublimation under vacuum. This avoids prolonged exposure to liquid water and high heat.
Lowering pressure reduces the boiling point of water and allows ice to sublimate at temperatures below freezing. Vacuum also limits convective heat transfer, so heat is usually supplied by shelves or radiation. The pressure must stay below the vapor pressure of ice at the product temperature.
The cycle typically includes freezing, primary drying, and secondary drying. Freezing solidifies water and sets the pore structure; primary drying removes bulk ice; secondary drying removes bound water. Some cycles add annealing or pre-freezing steps.
Primary drying removes ice by sublimation at low pressure and low shelf temperature. Secondary drying removes bound water by raising the shelf temperature, often under the same vacuum. The two stages differ in the water state being removed.